Removing Door Handle Small Hole

Against the door where that notch is located will be a very small section where you can insert a flat head screwdriver.

Removing door handle small hole.

You should see a tiny slot or hole. After you ve unscrewed or loosened the latch tug on the door knob until it pops out of place or disengages from the base also known as the rose. Locate the hole underneath the doorknob shaft. How to remove a door knob without screws or a latch.

Apply a bit of pressure to the paper clip to trigger a release button inside the hardware. Pull out the latch plate and door latch mechanism. Look on the neck of the inner doorknob for a slot or hole between the back of the doorknob and the door. Keep in mind that you only need a very small amount of separation.

Look for pin holes in the rose or in the lever body itself. You do not want to pry the plate too far away. Step 2 straighten a large wire paper clip out and insert one end into the hole until you feel the spring loaded retaining pin. Open the door so that you can access both the inner and outer doorknobs.

You should now just have holes in your door into which you can install a new door handle. If there s one present you ll be able to depress a button or loosen a small screw inside the hole to release the handle. Push the tip of a narrow screwdriver into the hole. If your door has no visible screws check the neck of the knob or lever for a small hole.

Look for a recessed slot in the shaft of the handle. Once triggered the lever or lock trim can be removed from the door. Straighten a paper clip and insert it into the hole.