Remove the door handle bezel by inserting a flat trim removal tool between the door panel and handle bezel to release the locking tabs.
Removing door panel on 2011 silverado.
Then pull the door panel starting at a lower corner and lift the panel up.
Use a 7 mm socket wrench or a ratchet extension and 7 mm socket.
Remove all door panel electrical connectors.
It just pulls right out.
Now you want to remove this 10mm bolt and these two 10mm bolts right here.
Move to the bottom edge of the door panel carefully insert a flathead screwdriver or an automotive trim panel removal tool and gently pop out the friction fasteners.
Remove the two 10mm bolts inside the door pull.
Locate and remove the door panel retaining screw underneath the rear of the window control module cavity.
Then you want to do the same thing to the panel on the other side.
Start off by prying up this panel behind the pole handle and then pry out this little panel beyond your door handle.
Free shipping on many items.
You need to remove the 2 bolts that hold the pull handle on there is 1 bolt behind the door handle that opens the door and there are 2 behind the handle that is directly behind the switches.
Remove the 10mm bolt inside the door handle.
2011 door panel removal.
Lift the door panel up and out to release the door panel locking tabs.
Jan 24 2013 1 58pm i believe there s a little pin on the underside of the base on the inside release handle that when you push up it should pull right off.
Remove the two 10mm bolts underneath the handle.
Now pry off this panel.
Just pull out the clips on the back.
Pull the lock up and pry out the panel on the lock.
Continue pulling on the bottom and sides of the panel to disengage all of the white plastic friction fasteners.
2011 chevrolet silverado 1500 134 10.
Remove the panel under the handle.
Gently lift panel up.
Also replaced the door handle cable.
07 13 chevrolet silverado 1500 door panel rear right passenger black 1119 06 fits.
How to on removing the door panel and replacing the inside door handle on dads 2013 gmc sierra 2500hd.
Then open the clip on the front of the door lock knob use something thin.
Pry out the door panel with a door panel clip tool or putty knife.
Disconnect the switch wiring harnesses.
We ll fast forward as don does this.
Lift the door panel up and off.
Disconnect the latch cables from the door handle with pliers.
Pry up the window switch panel.
Life the lock up and off.
